36 24V/12V CONVERTER FOR RADIO/CB
The following description of the operation
and connection is intended as a general
guideline only.
Also refer to the manufacturer’s
installation instructions supplied with the
radio.
If the contact switch (C539) is switched to
accessory position 1, pin 1 is connected to pin
6 (wire 1100 is connected to wire 1130). As a
result, a voltage is applied to connection point
85 of relay G178. This is activated. A voltage
is now applied to connection point 1 of relay
G377 through fuse E037, wire 1100, contacts
30 - 87 of relay G178, wire 1147, fuse E052
and wire 1110. This is activated. There is now
a power supply of 12 volts to connection point
A7 of the ’ISO’ connector through wire 1108,
contacts 3 - 5 of relay G377 and wire 1363.
The radio has an aerial connection and two
loudspeaker outputs, to which the speakers
B024 and B025 are connected. Two high
volume and two low volume speakers (B178,
B179 and B180 and B181) can also be
connected to the radio.
CB
Wire 1108 is also available (in a white
connector) to use for a transmitter (B026).
This connector is in the roof console on the
driver’s side.
For more information, see block 6,
Connecting accessories.
Комментариев нет:
Отправить комментарий