DAF 95XF Коробка отбора мощности

38. GEARBOX PTO

Operation

If the contact is activated, a voltage is applied to

the electronic unit CWS (D853) pin 14.

A voltage is then also applied to C750 and C751

(PTO control switch) through fuse E016 and

wire 1217.

If the PTO control switch (C750) is engaged, a

voltage will be applied to E570 (control switch

clutch/PTO N/10) and to contact 3 of relay

G259. Switch E570 will make a connection

between contacts 1 and 2. As a result, both

relay G259 will be activated and a voltage will

be applied to connection point 1 (through wire

4596) of B245. The relay will establish a

connection to connection point 1 of valve B245

through contacts 3 and 5.

If the PTO control switch (C751) is engaged, a

voltage will be applied to B246 (PTO control

valve). As a result, valve B246 is activated.

VARIANTS

Location

25 In the case of 4x2, connector 373 and unit

D851 are used.

In the case of 6x2, connector 445 and unit

D802 are used.

45 This depends on the speed-limiter type.

Connector 378 is used if the E-gas system

is applied.

Connector 433 is used if the ASL-G is

applied.

Connector 434 is used if the ASL-V is

applied.

Оглавление...